Troubleshooting & Print Adjust; Master Reset - Pyramid 2500 User Manual

Auto Aligning time CloCk inStRuCtionS
model 2500/2650
TROUBLESHOOTING
TIME CARD MISFEED
In the event the time card will not feed, re-feed the time card. If issue persists, please
check list for possible causes:
TIME CARD MISFEED
POSSIBLE CAUSES
Time card inserted too hard into time clock
Time card held too long
Time card inserted into time clock on an angle
Time card is wet or damaged
WRONG SIDE PRINTING
PROBABLE CAUSE
Time card is facing wrong way
IMPAIRED PRINTING
In the event the time clock printing is impaired, please check list for possible causes:
IMPAIRED PRINTING
SYMPTOM
Time card feeds
with no printing
Punches print outside
of date box

MASTER RESET

Erases time clock's memory & restores default factory settings.
1
Unlock & remove time clock cover.
2 Slide SETTING switch to right to
begin "reset" setting mode.
In SETTING mode, press the 1st,
3
5th and 6th column buttons at the
same time.
4 Re-program time clock.
COLUMN RESET
DELETING A SETTING
Slide the "SETTING" switch to right.
1
Press the 2nd, 5th and 6th column buttons at same time to reset to default
2
settings.
3
Re-program time clock.
14 TROUBLESHOOTING, PRINT ADJUST & MASTER RESET
ACTION
Make sure correct date on time card side is facing user
PROBABLE CAUSE
Ribbon not installed properly
Print needs adjustment
ACTION
Check that ribbon cartridge is
properly installed. See page 13.
Follow Print Adjustment
instructions on page 10.
+
Enter
Setting
PM
24
ACTION
Re-Feed Card
Re-Feed Card
Re-Feed Card
Use new time card
Back Clear
Reset
888.479.7264