Maintenance - DeWalt XR LI-ION DCS377 Original Instructions Manual

English
Recommended Cutting Positions
YES
YES
YES

MAINTENANCE

Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
The charger and battery pack are not serviceable.
C
Lubrication
Your power tool requires no additional lubrication.
D
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non‑metallic parts of the tool. These
14
NO
Optional Accessories

NO
Consult your dealer for further information on the
appropriate accessories.
Tool Connect™ Chip (Fig. I)

Your tool is Tool Connect™ Chip ready and has a location for
installation of a Tool Connect™ Chip.
Tool Connect™ Chip is an optional application for your
smart device (such as a smart phone or tablet) that connects
the device to utilize the mobile application for inventory
management functions.
Refer to Tool Connect™ Chip Instruction Sheet for
more information.
installing the Tool Connect™ Chip
1. Remove the retaining screws
2. Remove the protective cover and insert the Tool Connect™
3. Ensure that the Tool Connect™ Chip is flush with the
4. Refer to Tool Connect™ Chip Instruction Sheet for
Transport

•
•
•
•
Storage

•
•
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
Connect™ Chip protective cover
Chip into the empty pocket
housing. Secure it with the retaining screws and tighten
the screws.
further instructions.
CAUTION: Accidental starting during transport!
Always transport your products with the batteries removed!
Transport the tool and batteries individually packaged.
Follow the information in the section Battery Packs –
Transportation in this manual.
Check the tool and batteries for damage before use
after transport.
CAUTION: Accidental damage caused by defective or
leaking batteries!
Always store your products with the batteries removed!
Store the tool and batteries in a place that is as cool and dry
as possible.
WALT recommended
e
( 24 that hold the Tool
into the tool.
23
25 .