Table of Contents
Advertisement
Menu Item
[Graphic EQ]
[Super Bass (S.Bass)]
[Powerful] [Natural]
[Vocal] [Flat] [Dynamic]
[Vivid] [Custom1]
[Custom2]
[Subwoofer]
[On] [Off]
[Crossover]*5
[Dynamic Bass Enhancer]
[Off] [Low] [High]
[Rear Speaker Output]
[Rear] [Subwoofer]
[Mute Level]
[ATT]
[Mute]
[Off]
[Subwoofer Settings]*5
[Save Settings]
Description
Select or customise the equaliser curve.
Select a curve that you want to use as the basis of
customising then touch the frequency that you want to
adjust.
TIPS
• If you make adjustments when a curve [Super Bass (S.Bass)],
[Powerful], [Natural], [Vocal], [Flat], [Dynamic] or [Vivid] is
selected, the equaliser curve settings will be changed to
[Custom1] mandatorily.
• If you make adjustments when the [Custom2] curve is selected
for example, the [Custom2] curve will be updated.
• [Custom1] and [Custom2] curves can be created common to all
sources.
• If you trail a finger across the bars of multiple equaliser bands,
the equaliser curve settings will be set to the value of the
touched point on each bar.
Select enable or disable rear subwoofer output from this
product.
Select a speaker unit (filter) to adjust the HPF or LPF cutoff
frequency and the slope for each speaker unit (page 100).
Increases the bass boost level and gives sound a more
dynamic effect.
Select the rear speaker output.
NOTE
This function is available when [Standard Mode] is selected as the
speaker mode.
Select mute or attenuate the AV source volume and iPhone
or smartphone application volume when the navigation
outputs the guidance voice.
The volume becomes 10 dB lower than the current volume.
The volume becomes 0.
The volume does not change.
Select the subwoofer phase (page 100).
Save to recall the following current sound settings by
touching [OK]: slope, subwoofer phase, speaker level,
Graphic EQ, HPF/LPF, listening position, crossover, time
alignment.
TIP
When you touch [Cancel], return to the [Audio] setting screen.
- 99 -
Advertisement
Table of Contents
