Advertisement
Troubleshooting
Malfunction display and solutions
Please read the issues below carefully and try all relevant steps.
If none of this helps, please contact us on 1300 11 4357 for further
advice or to schedule a technician to inspect your dryer.
Malfunction display and solutions
Dispiay
Container is full
LED on
"Full"
Water pump failure or water
permanently
Precautions
level sensor failure
Temperature sensor failure
Child Lock + 9h
Precautions
Humidity sensor failure
Child Lock + 6h
Only authorised technicans can carry out repairs.
Before you call customer service, please check if you have deal with the fault by yourself
Child Lock + 3h
Heater failure
or if you have follow the user instructions.
(
)
Only
MDS70-C05/B08-AU(2)
A technician will charge you for advice, even during the warranty period.
Problem
•Working state LED
not on
• "Full"LED on permanently
•Dryer does not start
•Water is running out
•Door is open by itself
•Humidity in the room is
increase significantly
•Degree of dryness was
reached or drying time too
long
If you cannot deal with the faulty by yourself and need help:
1.Press the button 【
MAINTENANCE
Problem
•Working state LED
not on
•
"Full" LED on permanently
Reason
•Dryer does not start
•Water is running out
•Door is open by itself
•Humidity in the room is
increase significantly
•Degree of dryness was
not
reached or drying time too
Solution
long
•The mains plug is inserted.
•Check the programme selected.
•Check fuse in the house.
Warning!
！
•Empty condensation container.
If you cannot deal with the fault by yourself and need help:
• Press the 【On/Off】button.
•If failure, check hose for condensation outlet.
• Pull out the mains plug and call the service.
•Check the
start button
•Check the the door has closed.
•Check the programme has set.
•Align dryer horizontally.
•Clear air condenser and door seals.
•Press door until it "clicks"into position.
•Check the clothes is over load .
•Ventilate room adequately.
•Clean the cool grille.
•Ensure that the air condenser has been inserted.
•Clean lint filter and wash condenser.
•Empty container.
not
•Check water outlet.
•Dryer installation too restricted.
•Clean the moisture sensors.
•Use next higher drying programme or using Timer
programme.
On/Off
】.
User Manual
Solution
•The mains plug is inserted.
•Check the programme selected.
•Check fuse in the house.
•Empty condensation container.
Solutions
•If failure, check hose for condensation outlet.
•Check the
start button
has selected
Empty container
•Check the the door has closed.
•Check the programme has set.
•Align dryer horizontally.
•Clear air condenser and door seals.
P lease contact your
•Press door until it "clicks"into position.
•Check the clothes is over load .
local service center
•Ventilate room adequately.
if the problem
•Clean the cool grille.
persists
•Ensure that the air condenser has been inserted.
•Clean lint filter and wash condenser.
•Empty container.
•Check water outlet.
•Dryer installation too restricted.
•Clean the moisture sensors.
•Use next higher drying programme or using
Timer programme.
has selected
.
19
14
Preca
Precau
.
•Wo
• "Ful
•Drye
•Wate
•Door
•Hum
incre
•Degr
reach
long
Only
Befo
or if
A tec
not
If y
1.P
2.P
Advertisement
