Basic Operations; Mechanism Of Auto Functions (Sw3074T40, Sw3074); Using The Control Panel; Drying - Toto SW3024 Instruction Manual

Basic Operation

Mechanism of Auto Functions (SW3074T40, SW3074)

"EWATER+" is used automatically to clean the wand.
As you approach As you sit
Removing odors inside the bowl unit.
● Deodorizing fi lter needs regular
maintenance. (Page 33)
A mist is automatically sprayed inside the bowl
unit to make it more difficult for dirt to adhere.
The above are default setting
functions.
"EWATER+" helps the self-cleaning wand feature work eff ectively
● These may be changed.
and by preventing the accumulation of dirt that can cause stains.
→ "Various Operations"
• "EWATER+" is generated from chemicals already present in potable water.
(Pages 24 - 27)
• "EWATER+" helps to minimize dirty surfaces, but does not make cleaning
unnecessary.
• The eff ect of rinsing with "EWATER+" can vary depending on the frequency
Auto wand CLEAN
of toilet use and other conditions.
During
"EWATER+" can also be used by pressing the button on
"Auto wand CLEAN"
the control panel.
or "Wand CLEAN"
■Wand
Flashes
*1 To keep clean the wand every time it is used, water remaining in the wand is drained after you stand up from the toilet seat.
*2 When the washing functions (Rear washing and Front washing etc,) have not been used in 8 hours, the wand is cleaned
automatically. (Water comes out from around the wand.)
16
As you stand up
0
(sec) 10 25
Deodorizer
After about 10 seconds
Starts
the deodorizer
Starts the auto
power deodorizer
It stops after about 60 seconds.
Auto wand CLEAN
Only when the washing functions are used.
After about 25 seconds
The wand extends to clean
itself with "EWATER+" that
comes out of the base
Pre-mist
Pre-mist
What is meant by "EWATER+" ?
Press
(After wand cleaning, water comes out from around the wand.)
●To clean the wand with it extended. "Wand cleaning" (Page 33)

Using the Control Panel

"Rear
*1
Washing washing"
• Washes your rear.

Drying

"Stop"
Stopping
• Stops the
*2
˂The drawing is SW3074˃
*3 Except SW3024
● Functions that operate
when a button is
pressed during "Rear
■ "Water pressure adjustment"
washing", "Rear soft
washing" or "Front
washing".
Note
• Sitting back on the toilet seat makes it easier to adjust the wand position and to reduce splashing.
 Water may sometimes come out from around the wand when it expands in the warm water tank, but this is normal.
 As the warm water tank of hot-water system is used, the temperature of warm water may become lower if it is continuously
consumed.
"Rear soft washing"
• Washes your rear with mild water
pressure.
"Front washing"
• Serves as a bidet for ladies.
"Warm air drying"
• Dries your rear.
operation.
■ "Power deodorizer"
Pressing the button increases the deodorizer power
 This button is only enabled when sitting on
the toilet seat.
 When you stand up without turning the button
off , it automatically stops after about 60 seconds.
■ "Power ON/OFF"
 Pressing it about 3 seconds or longer turns the
power on/off .
Temperature setting, Temperature adjustment LED (Page 18)
 Adjust temperatures
■ "Wand CLEAN"
Cleans the wand with "EWATER+".
 This function will operate automatically after using
the washing functions (Rear washing, Front
washing, etc.). (Page 16)
■ "Pulsating washing"
Washes with the water pressure pulsating between soft and strong.
■ "Wand position adjustment"
You can adjust the washing position as desired to 5
diff erent points.
You can adjust the water
 The washing position returns to the standard position
pressure to one of fi ve levels.
 The PRESSURE LEDs illuminate (3rd point) when you stand up from the toilet seat.
when you sit on the toilet seat.
For your information
*3
"Oscillating washing"
• When you press this button
again during use, the wand
moves back and forth to
wash your rear thoroughly.
*3
Main display
(Page 13)
*3
(Page 16)
17