Before Use; Installation; Operation - Prem-I-Air EH1461 Manual

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.

BEFORE USE

You must inspect the product including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your
supplier immediately.

INSTALLATION

Place the appliance on a firm, flat level surface.
If continuous drainage is to be used, unscrew and remove the bung from
the drainage port (on the back of the appliance, half-way up, on the right-
hand side), and connect a drainage hose to the port. Use a hose with an
internal diameter of 12mm (½"). Make sure that the hose runs downwards
throughout its entire length, and has no kinks. Otherwise the drainage will
not work.
The bung can be stored in the bucket in case it is required at a later date.
Make sure that the bucket is fitted correctly into the housing.

OPERATION

• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 3
Amps, and that it is fully unwound.
• Place the appliance on a firm flat level surface.
• Switch the appliance on at the mains socket. Then press the power
switch to start operation.The appliance will wait for 3 minutes whilst the
refrigerant settles before starting to operate, this is to extend the life of
the compressor.
• Using the + and − buttons, set the required humidity level on the display.
The level can be set between 35% and 80% in 5% increments. The
appliance will remove humidity from the air whenever the humidity level is
higher that the set level.
After a delay of 5 seconds, the display changes to showing the present
room humidity level.
• To select continuous operation, press the CONT. button. The appliance
will continuously remove humidity from the air regardless of the humidity
Page 2