Installing Printer Software For Windows - Epson Stylus Pro 5500 Printer Manual

1-18 | Setting Up the Printer
Note
If you'll be using the
optional RIP software
drivers to control your
printer instead, see the
documentation on the RIP
software CD-ROM for
instructions on installing
and using the software.
Note
If you're using Windows
2000 and connected your
printer with a parallel
cable or network interface
card, click the Stop
Searching button at
step 6 and go to step 7.

Installing Printer Software for Windows

After connecting the printer to your computer, you need to install the
printer driver and utilities included on your printer software CD-ROM.
Follow these steps:
1. Make sure your printer is turned off.
2. Turn on your computer and start Windows. If the New Hardware
Found screen or Add New Hardware Wizard appears, click
3. Insert the printer software CD-ROM in a CD-ROM or DVD drive.
After a moment, this dialog box appears:
click here
4. Click
Install Printer Driver
5. Click in the next window to start printer software installation. You
OK
see windows opening on your screen during driver installation. On
Windows 95 and NT, the Status Monitor 3 utility is also installed now.
6. Windows 95 or NT: Turn on your printer and go to step 7.
Windows 98, Me, or 2000: You see a window asking you to turn on
your printer. Press the P
comes on. After a few moments, the software configures your printer
port and installs the Status Monitor 3 utility.
1-18
, then click the
button until the P
Operate
.
Cancel
then click
here
icon.
light
Operate