Hawksmoor CS5300-3 Original User Instructions page 7

manufacturer. Use of other accessories may result in an
accident. Read the "Technical Data" section of this instruction
manual or ask your dealer for advice.
• Do not lean. Keep a good seating and balance at all times.
• To maintain tools and accessories carefully, keep cutting tools
sharp and clean for better and safer performance. Follow the
instructions in this manual to lubricate and change accessories.
• Always inspect the machine before and after operation. If the
tool is damaged or faulty, stop using the tool and bring it to an
authorized service for inspection and repair.
• Turn off the tool after use, when you leave it unattended, when
changing these accessories and before servicing.
• Keep handles dry, clean and free from oil and grease.
• Be concentrated when using the tool. Look at what you do,
make sense and do not use the tool when you are tired.
• Remove the blade guard before using the tool.
• A damaged guard or other part must be properly repaired or
replaced by an authorized service center, unless otherwise
specified in this instruction manual.
• Do not use the tool if the starter is not working (if it cannot be
turned ON and OFF).
• Place the equipment in a well-lit area on a flat, stable, dry and
well-ventilated surface, away from flammable materials and with
plenty of space for sparking and sharpening waste.
• Do not allow anyone, especially children, to come within a radius
of at least five meters around the work area when all work is in
progress.
• Immediately stop the tool in the event of a malfunction of the
motor or the ON/OFF button or in case of unusual noise.
• Do not use the tool if the starter is damaged.
• Do not move the chain with your hand with the wheel moving.
7