Table of Contents
Advertisement
Figure 57. Removing the serial connector module
Figure 58. Installing the serial connector module
6. Reinstall the removed parts. To complete the replacement, see "Completing the parts replacement" on
page 57.
Replacing the M.2 solid-state drive
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove the computer stand. See "Replacing the computer stand" on page 16.
2. Remove the computer cover. See "Removing the computer cover" on page 17.
3. Remove the side I/O bezel. See "Replacing the side I/O bezel" on page 23.
4. Remove the system board shield. See "Replacing the system board shield" on page 24.
5. Depending on your computer model, refer to one of the following to replace the M.2 solid-state drive.
• Type 1
.
Chapter 4
Replacing hardware
39
Advertisement
Table of Contents
