Epson Stylus Pro 3880 Network Manual page 13

3. Check if the following network components are in the list. If they are
already installed, go to "Connecting the Network Interface to the Network"
on page 16.
The following table lists the network components required for configuring
the network interface with EpsonNet Config.
EpsonNet Config's setting screens
TCP/IP, SNMP (IP trap)
The following table lists the network components required for network
printing.
Printing method
LPR printing
4. If the necessary components are not in the list, click Install to install them.
5. Double-click Internet Protocol Version 4 (TCP/IPv4) on the Local Area
Connection Properties dialog box to open the Internet Protocols Version 4
(TCP/IPv4) Properties dialog box. Set the IP address, the subnet mask,
etc. and then click OK.
6. Restart the computer.
The necessary components are now installed. Go to the section "Connecting
the Network Interface to the Network" on page 16.
Necessary components
Internet Protocol (TCP/IP)
Necessary components
Internet Protocol (TCP/IP)
Setting Up Your System for Network Printing
13