Advertisement
UnInstalling the Drivers
Figure 5
6
To remove the GPS 35 USB drivers from your computer
1. Insert the GPS 35 USB Driver CD-ROM into your computer's
CD-ROM drive.
2. Unplug the USB connector from your computer.
3. From your Desktop, click "Start" then "Run".
4. Type: <CD-ROM drive letter>:\USBUninstall.exe
(Example if your CD-ROM drive letter is 'E': E:\usbuninstall.exe)
5. Click and put a check in the "U232-P9" box. (Fig. 5)
6. Click "Uninstall". Reboot your system when prompted. Remove the
GPS 35 USB driver CD when done.
Disconnecting the GPS 35 USB from Your Computer
After the GPS 35 USB has been successfully installed (hardware
and software), disconnecting and reconnecting the GPS 35 USB can
performed without additional installation steps.
1. Close any programs which are receiving input from the GPS 35.
2. Unplug the USB connector from your computer. You do not need
to turn the computer off before removing or inserting the USB
connector. The next time you need to use the GPS 35 USB, simply
plug it into your USB port and use as needed.
Advertisement
