Table of Contents
Advertisement
FCC Radio Frequency Interference Requirements
This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency
range.
FCC requires this product to be used indoors for the frequency range 5.15 to 5.25 GHz to
reduce the potential for harmful interference to co-channel Mobile Satellite systems.
Radio Specifications
Data transfer rates
Standards supported
Transmission method
Wireless channels used
RF frequency band
USER INSTALLER CAUTION:
Your authority to operate this FCC certified equipment could be voided it you make changed
or modifications not expressly approved by this party responsible for compliance to part 15
FCC rules.
NOT: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiates radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help and for additional
suggestions
The user may find the following booklet prepared by the Federal Communications
Commission helpful :
This Booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402,
Stock No. 004-000-00345-4.
FCC Warning
The User is cautioned that changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
FCC ID : A3LSTR2100 & A3LSHP2100
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions;
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC RF Exposure Warning(A3LSHP2100)
This equipment compiles with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment has been approved for portable operation, and unless otherwise advised in
separate supplemental instructions for individual wireless transmitter(s), requires minimum
1.5 cm spacing be provided between antenna(s) and all by-standing's body (excluding
extremities of hands, wrist and feet) during wireless modes operations.
FCC RF Exposure Warning(A3LSTR2100)
In order to comply with FCC RF Exposure Requirement,
Please maintain a minimum 20cm spacing between the body of the user and the device antenna.
IEEE802.11a:54/48/36/24/18/12/9/6Mbps
(automatically switched)
IEEE802.11a
OFDM system
IEEE802.11a: Channels 36, 40, 44
IEEE802.11a: 5.18~5.22 GHz
"How to Identify and Resolve Radio-TV Interference Problems."
Advertisement
Table of Contents
