Table of Contents
Troubleshooting
Related Manuals for Eskimo Z71Q10
Summary of Contents for Eskimo Z71Q10
- Page 1 ® ASSEMBLY INSTRUCTIONS & PARTS EXPLOSIONS SHARK ICE AUGERS Z71Q10, Z71Q9, Z71Q8, Z71T8 Z51Q10, Z51Q9, Z51Q8, Z51T8 ARDISAM .com OMZ51/Z7107 Rev. 12/4/06 © Copyright 2006 Ardisam, Inc. All Rights Reserved. Printed in USA.
-
Page 2: Warranty
Eskimo® Power Ice Auger from Ardisam, Inc. We the engine, not to exceed twelve consecutive months from have worked to ensure that the ice auger meets high standards for the date of purchase. -
Page 3: Owner's Responsibility
• Carefully follow all assembly instructions. • Maintain the auger according to directions and schedule IMpORTANT included in this Eskimo operator’s manual. INdICATES hELpFUL INFORMATION FOR pROp- • Ensure that anyone who uses the auger is familiar with all ER ASSEMBLY, OpERATION, OR MAINTENANCE controls and safety precautions. -
Page 4: Engine Safety Precautions
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models ENGINE SAFETY pRECAUTIONS • Allow fuel fumes/vapors to escape from the area before starting engine. Warning Carbon Monoxide poisoning • Test the fuel cap for proper installation before starting and All engines contain carbon monoxide in their exhaust. Carbon using engine. -
Page 5: Operation
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models OpERATION CAUTION STEpS FOR WORkING ON ENGINE OR AUGER dO NOT ALTER/MOdIFY ENGINE OR AUGER: 1. Turn off engine switch. AvOId INjURY! NEvER ALTER OR MOdIFY ThE 2. Disconnect the spark plug wire from the spark plug. ENGINE FROM ThE FACTORY. -
Page 6: Normal Operation
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Filling Gas Tank CAUTION 1. Shut-off engine and allow engine to completely cool before refill- ing the gas tank. AvOId INjURY! ALWAYS hANdLE FUEL IN A WELL 2. Move to a well ventilated area, outdoors, away from flames and vENTILATEd AREA, OUTdOORS, AWAY FROM sparks. -
Page 7: Starting And Stopping Engine
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models STARTING ANd STOppING ENGINE CAUTION • Move engine to a well ventilated area, outdoors, to prevent car- bon monoxide poisoning. AvOId INjURY! ALWAYS hANdLE FUEL IN A WELL • Move to an area away from flames or sparks, to avoid ignition of vENTILATEd AREA, OUTdOORS, AWAY FROM vapors if present. -
Page 8: Maintenance And Storage
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models hOT ENGINE START: CAUTION 1. Open gas cap vent screw all the way (counterclockwise). 2. Continue with Step 5 of Cold Engine Starting. TO pREvENT ACCIdENTAL STARTING: 3. If engine does not fire, refer to Step 2 of Warm Engine Starting. AvOId INjURY! ENGINE MUST BE TURNEd OFF ANd COOL, ANd SpARk pLUG WIRE MUST BE RE- dO NOT attempt to start engine in the following ways:... - Page 9 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Spark plug CAUTION The recommended spark plug is a NGK BM6A which cross refer- ences to a Champion CJ8. AvOId INjURY! TO AvOId INjURY OR dEATh, NEv- 1. Check spark plug every 50 operating hours. ER SIphON FUEL BY MOUTh.
-
Page 10: Service, Troubleshooting And Repair
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models SERvICE, TROUBLEShOOTING ANd CAUTION REpAIR SERvICE INFORMATION AvOId INjURY! AUGER BLAdES ANd pOINT ARE ExTREMELY ShARp. USE CAUTION WhEN RE- At Ardisam, we build quality and durability into the design of our MOvING &... -
Page 11: Troubleshooting
® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models TROUBLEShOOTING pROBLEM pOSSIBLE CAUSE REMEdY/ACTION Engine will not start 1. Power switch off 1. Flip switch to ON position 2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug 3. - Page 12 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z71 ShARk ENGINE pARTS ExpLOSION page 1 800-345-6007...
- Page 13 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z71 ShARk ENGINE pARTS LIST pART pART dESCRIpTION QTY. dESCRIpTION QTY. 3004142 FLYWHEEL, MAGNETO 3004132 SCREW, THROTTLE LEVER 300337 NUT, FLANGE M8 300455 PLATE, INTAKE COVER ADAPTER 300462 WASHER, ROTOR 300457 COVER, AIR FILTER 300413 CLUTCH ROTOR ASSEMBLY 300435...
- Page 14 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z51 ShARk ENGINE pARTS ExpLOSION page 14 800-345-6007...
- Page 15 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z51 ShARk ENGINE pARTS LIST pART pART dESCRIpTION QTY. dESCRIpTION QTY. 300484 FLYWHEEL, MAGNETO 300489 LEVER, CHOKE 300337 NUT, FLANGE M8 300328 CHOKE COVER 300462 WASHER, ROTOR 3004132 SCREW, THROTTLE LEVER 300413 CLUTCH ROTOR ASSEMBLY 300455 PLATE, INTAKE COVER ADAPTER...
- Page 16 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z71 ShARk pOWERhEAd & AUGER pARTS ExpLOSION page 16 800-345-6007...
- Page 17 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z71 ShARk pOWERhEAd & AUGER pARTS LIST pART pART dESCRIpTION QTY. dESCRIpTION QTY. 3004711 GAS ENGINE, 71CC 232A BLADE PROTECTOR KIT 8” QUANTUM 8952 HANDLEBAR COMPLETE 233A BLADE PROTECTOR KIT 3004197 TRANSMISSION COMPLETE 9”...
- Page 18 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z51 ShARk pOWERhEAd & AUGER pARTS ExpLOSION page 18 800-345-6007...
- Page 19 ® ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS Shark Models Z51 ShARk pOWERhEAd & AUGER pARTS LIST pART pART dESCRIpTION QTY. dESCRIpTION QTY. 300418 GAS ENGINE, 51.7CC IN58 NUT-NYLOC 5MM X 0.8 8952 HANDLEBAR COMPLETE 232A BLADE PROTECTOR KIT 8” QUANTUM 3004146 TRANSMISSION COMPLETE 233A BLADE PROTECTOR KIT...
- Page 20 ® Eskimo, Division of Ardisam, Inc. 1690 Elm Street Cumberland, Wisconsin 54829 800-345-6007 · Fax (715) 822-2223 Email: info@ardisam.com ARDISAM .com...
Need help?
Do you have a question about the Z71Q10 and is the answer not in the manual?
Questions and answers