Epson Stylus Photo 825 Printer Basics Manual page 100

Paper doesn't eject fully or is
wrinkled.
If the paper doesn't eject
fully, you may have set the
wrong paper size. Press the
b maintenance button to eject
the paper, then select the correct
paper size.
If it's wrinkled when it ejects,
the paper may be damp or too
thin. Load new paper.
Roll paper doesn't feed correctly.
To load roll paper correctly,
gently hold the paper in place
with your hand while you press
the z button. Don't force the
paper to feed into the printer.
Allow the paper to feed
automatically.
If paper is curled, roll the paper
inside a folded sheet of paper in
the direction opposite to the
paper's curl. You don't need to
uncurl the entire roll—only
about 9 inches. See page 25 for
instructions.
Use a triangle or other tool to
make sure the end of the roll is
cut perpendicular to the edges.
If the end is cut on a diagonal,
the paper may not feed
smoothly.
94
Solving Problems
If you see a paper jam error
message, press the z roll paper
button for four seconds to clear
the error.
If the red b error light is on,
press the b maintenance
button and wait for the light to
go off. Then press the z roll
paper button to resume
printing.
Remove the paper support and
close the output tray extensions.
Always select
Roll Paper
as the Paper Source setting.
If (or
Auto Sheet
Sheet Feeder
) is selected, paper will
Feeder
feed unnecessarily after each
print job. In addition, a great
deal of paper may feed
unnecessarily when you turn
your computer off and then on
again.
If extra paper feeds after a print
job or after you turn on the
printer, press the z roll paper
button for three seconds to
rewind the paper. (You may
need to repeat this step to
rewind the paper completely.)
Then press the b maintenance
button to turn off the
light. Finally, reload the paper
and press the z roll paper
button again to resume
printing.
b error