Table of Contents
Advertisement
Emptying the Collection Tank
1
2
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum. (Fig. 2)
3. Undo the latches and remove the power head from the collection tank. (Fig. 3) Place power
head on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose. (Fig. 4)
5. Clean or replace the filters.
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
7. Place power head on collection tank and secure latches.
IMPORTANT! Clean or change the cartridge filter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the cartridge filter,
the motor will burn out and the warranty will be voided. Always keep spare filters on hand.
NOTICE! The filters included are made of high quality materials designed to stop small dust
particles. The cartridge filter should be used for dry pick-up only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it will clog quickly and be very difficult to clean. Handle
the filter carefully when removing it for cleaning and replacing it. Check the filters for tears or small
holes, a small hole can let dust pass through and out of the filter. Do not use a filter with holes or
tears; replace it immediately.
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM COLLECTION TANK.
Storage
1
2
Before storing your vac, the collection tank should be emptied and cleaned. The cord should be
wrapped and hung on the hook of the handle. The hose and accessories should be stored as
illustrated above (Fig. 1-3) so they can be readily available when needed. Store vac indoors.
MAINTENANCE
3
4
3
10
Advertisement
Table of Contents
