Table of Contents
Advertisement
4. Connect your two receiver antennas to the RF input BNC connectors on the front panel
of the unit. When using powered antennas or remote line amplifiers, turn on the
"Antenna" power switch. For all other uses, leave this switch turned off.
5. Connect the PSC RF Multi SR Four Pack cable mounted SMA connectors to your slot
receivers using a "Criss cross" or X pattern. In some situations, it may make more sense
to keep the RF cables aligned with the receivers rather than crossed. Either way is
acceptable. See photo below:
6. Power up the unit. Note that the power switch lights up green when the unit is turned
on.
*NOTES*
1.
When used with ENG "bag" mixing setups, we recommend that you remotely
mount your receive antennas up and away from your equipment. This will help
eliminate picking up of RF spray from digital recorders.
2.
Different brands of wireless receivers require their own specific brand made
adapters to work with our Four Pack. These are the same adapters required to install
the slot receivers in an Ikigami or Panasonic camera. For example:
Lectrosonics SRB requires their "SRUNI" kit.
Wisycom MCR42 requires their "SCK42-IK-PSC" kit.
Audio Limited A10-RX no adapter needed.
Advertisement
Table of Contents
