PSC RF MULTI SR 4 PACK Operation Manual page 8

Once the cover is removed, you will see the battery monitor jumper. It is located near the USB
power jack on the main bottom PCB. You can then move the jumper to the position desired.
The three positions are marked on the PCB:
Position "A" =
Position "B" =
Position "C" =
STEP BY STEP USE GUIDE:
1. Install your slot style receivers into the openings on the front of the PSC RF Multi SR
Four Pack noting the correct direction of the DB-25 connectors.
receivers into the slots until you feel the DB-25 connectors line up. Once you feel the
connectors line up, firmly press the slot receiver fully into place. Lock your receivers
into place using the screws on the receivers.
2. Connect your audio output cables from the four TA3M audio outputs or from the DB-
15ND connector to your mixer or recorder's inputs. Either connector type can be used
with either analog or AES digital signals.
3. Connect one or two batteries to the TB4M Chassis 4 pin connectors on the left side panel
of the unit.
14.8V Lithium Ion (Lithium NP-1 or any "Smart" Lithium Battery)
13.2V Nickel metal Hydride
12.8V Sealed Lead Acid (SLA) or Lithium Iron Phosphate (LiFEPO4)
Gently slide the