Table of Contents
Advertisement
RF DISTRIBUTION:
Your new PSC RF Multi RD 4 Pack contains RF distribution designed to provide proper, clean RF
distribution to your Slot Receivers. Each half of the diversity RF distribution contains a built in
DC bias circuit designed to be able to power external remote powered antennas and/or remote
RF amplifiers, an RF limiter to help guard against RF overload, RF bandpass filters (various ranges
available), a very low noise RF Amplifier, and a RF splitter. Each half of the RF circuitry also
contains its own, dedicated power regulation circuit. Two SMA connectors are provided on the
Left Side Panel as RF Outputs for use in sending RF to another RF 4 Pack or any RF receiver. These
SMA outputs are post bandpass filter so they are RF filtered.
POWER DISTRIBUTION AND METERING
This device also contains a built in Battery Distribution System (BDS). On the left Side Panel, you
will find two Battery Input connectors. These are 4 mini Mini XLR connectors and are wired with
the pins doubled up for higher current capacity. (Pins 1 & 2 are Ground (-) and Pins 3 & 4 are
Positive (+). You can use all typical battery types and chemistries such as NP-1 batteries, "Smart"
batteries, V-Lock batteries. You can use Nickel Cadmium, Nickel metal Hydride, Lithium Ion,
Lithium Iron Phosphate (LiFEPO4) or Sealed Lead Acid (SLA) batteries.
When you turn on the unit's main power switch located on the lower left corner of the front
panel, the unit will fully power up. There is a 4 LED, multi-color battery level meter located on
the lower right-hand corner of the front panel. This meter will indicate your battery level when
REAR PANEL SHOWING: (Left to right)
PSC Logo
Future Optional Equipment Cover Plate
SN Location
Frequency Range Information
Advertisement
Table of Contents
