Titan TTB2700PRW Instruction Manual page 22

Before you start
EN
Connection to the water supply
WARNING! This product is not intended to be connected to the
potable water mains!
Observe the regulations of your local utility company when connecting
the product to a water supply line! It is prohibited to connect this
product to the drinking water facility without a backflow preventer which
corresponds to EN 12729 Type BA or EN 61770! Make sure that the
hose is at least a diameter of min. Ø 12.7 mm (1/2") and is reinforced!
1. Attach the water inlet hose adaptor
(21) on the water inlet (6) (Fig. 16).
2. Attach a suitable water hose (not
included) onto the water supply and
then the other end onto the water
inlet hose adaptor (21).
3. Open the water supply.
NOTE: The water inlet hose adaptor (21) contains a filter (21a) to
protect the product against larger particles. Ensure the filter is fixed
appropriately in position. Do not use the water inlet hose adaptor
without filter.
Connection to power supply
1. Make sure the on/off switch (16) is in its off position ("0").
2. Connect the plug with a suitable socket.
WARNING! Check the voltage! The voltage must comply with the
information on the rating label!
If using an extension cord it must be suitable for outdoor use with
sockets protected against water splashing. Ensure the extension cord
is of the proper size and type for your product (≥ 1.5 mm2)!
WARNING! The electric supply connection shall be made by a qualified
electrician and comply with IEC 60364-1. It is recommended that the
electric supply to this machine should include a residual current device
that will interrupt the supply if the leakage current to earth exceeds 30
mA for 30 ms or a device that will prove the earth circuit.
3. Your product is now ready to be used.
22
TTB2700PRW byTITAN
21
6
Fig. 15
Fig. 16
21a