Remember To Measure Resistance; Lifetime Warranty; Foil Heating Mat System; Foil Heating Mat Specifications - adept technology HM140/1 Installation Manual

1.3 Remember to measure resistance

The resistance should be measured between the two conductors, blue and brown. Compare this
resistance reading to the resistance specified in the Product Selection Table. The value should be
within -5% to +10%. If you get a different reading, contact Adept at 01394 593110.
Also, measure the resistance between the blue, brown and yellow green ground wire. Both should
read infinity. If you get a different reading, contact Adept at 01394 593110.
Please refer to "5 Commissioning" for instructions on how to measure the resistance.
Important: measure the resistance three times during the installation process
Remember to always measure, verify and record the actual resistance throughout the
installation process (out of the box, after installation and after installation of wood floor).

1.4 Lifetime Warranty

From the date of purchase, Adept warrants that the Foil Heating Mat heating cable is free from
defects in material, design and workmanship. The extended warranty is only valid if the warranty
certificate has been properly completed and mailed, and the installation is in accordance with the
installation instructions.
2 Foil Heating Mat Systems

2.1 Foil Heating Mat Specifications

Cable Construction:
Rated Voltage:
Output:
Cable spacing:
Cable Diameter:
Conductor Insulation:
Max. Ambient Temp.:
Min. Installation Temp.:
Cold lead

2.2 Foil Heating Mat typical installations and applications

Warning
Consult the manufacturer for information on special installation requirements for wood, laminate
and vinyl or linoleum flooring.
Important
· Read the instructions carefully before installing Foil Heating Mat system.
Twin conductor
230V
2
140W/m
50mm
1.0mm
Fluorpolymer
30°C(85°F)
5°C(40°F)
2-wire plus ground braid; 2.5m length
2