Table of Contents
Advertisement
Step 9: MEASURE THE RESISTANCE (THE SECOND TIME)
Please refer to Step 5.
Step 10: INSTALL WOOD FLOOR COVERING
ENSURE THAT THE SENSOR CONDUIT HAS BEEN PROPERLY INSTALLED BEFORE
PROCEEDING (see Step 3).
Before fitting the floor covering switch on the heating mat to check that it is working - warmth
should be noticeable on the surface of the
heating mat within minutes. You are now
ready to lay the final floor finish. Take care
not to damage the heating mats. Do not
drive nails or screws into the floor or cut
the floor panels on top of the heater.
Important
If the floor is not being laid immediately,
all heating mats must be protected with
cardboard to prevent damage. Immediately
prior to the floor being laid, test the heating
mat to ensure it has not been damaged.
9
Advertisement
Table of Contents
