Advertisement
Available languages
Available languages
The power supply should be connected in compliance with the relevant
standard, or a single-pole circuit breaker. The method of connection is
shown below.
Attention
1. If the cable is damaged or needs replacing, this should be done by an
after-sales technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an
omnipolar circuit breaker must be installed with a minimum gap of 3mm
between the contacts.
3. The installer must ensure that the correct electrical connection has been
made and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly
qualified person
Product are imported and distributer by VINA STAR JSC.
Hotline: 1900 588 851
13
Advertisement
