Fein WSG 8-115 Instruction Manual page 20

3 41 01 050 06 0.book Seite 20 Dienstag, 12. Juni 2007 10:57 10
EN
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord.
Beware of any concealed electric cables, gas or water
conduits;
Never lay the power tool down until the accessory
has come to a complete stop.
Do not carry the power tool at your side while the
motor is running.
Causes of kick-back and precautionary
measures for the operator.
Hold the power tool firmly and position your body and
arms optimally to withstand any kickback forces.
Always use the original auxiliary handle so that kick-
back forces or the starting torque can be mastered
in the best possible way.
Never place your hand near the rotating acces-
sory.
Do not position your body in the area where the
power tool will move if kickback occurs.
Take special care when machining corners, sharp
edges, etc. Prevent the accessory from bouncing
off or tilting.
Do not attach a saw chain, wood-carving blade or
circular saw blade.
Additional safety instructions, particularly
for cutting operations.
Avoid jamming the cutting wheel or applying
excessive pressure. Do not attempt to make an
excessive depth of cut.
Do not position yourself in line with and behind the
rotating cutting wheel.
Switch the power tool off if the cutting wheel
blocks or if the cutting process is interrupted for
some reason. Hold the power tool motionless until
the cutting wheel has come to a complete stop.
Never attempt to remove the cutting wheel from
the cut while the wheel is still moving, otherwise
kickback may occur.
Do not restart the cutting operation if the cutting
wheel is in the workpiece. Let the cutting wheel
reach full speed and then carefully reenter the
cut.
Support the panels or any oversized workpiece to
minimize the risk of wheel pinching or kickback.