Outback OUT370665/PH300 Assembly And Operating Instructions Manual page 13

Signature stainless steel flame tower
Table of Contents

Advertisement

CAUTION
PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE
OPERATION.
Do not use the patio heater for indoors, as it may cause personal injury or
property
damage.
This outdoor heater is not intended to be installed on recreational vehicles and/or
boats.
Installation and repair should be done by a qualified service person.
Improper installation, adjustment, alteration can cause personal injury or
property damage.
Do not attempt to alter the unit in any manner.
Never replace or substitute the regulator with any regulator other than the
factory-suggested replacement.
Do not store or use gasoline or other flammable vapors or liquids in the heater
unit.
The whole gas system, hose, regulator, pilot or burner should be inspected for
leaks or damage before use, and at least annually by a qualified service person.
All leak tests should be done with a soap solution. Never use an open flame to
check for leaks.
Do not use the heater until all connections have been leak tested.
Turn off the gas valve immediately if smell of gas is detected. Turn Cylinder Valve
OFF. If leak is at Hose/Regulator connection: tighten connection and perform
another leak test. If bubbles continue appearing should be returned to hose's
place of purchase. If leak is at Regulator/Cylinder Valve connection: disconnect,
reconnect, and perform another leak check. If you continue to see bubbles after
several attempts, cylinder valve is defective and should be returned to cylinder's
place of purchase.
Do not transport heater while it's operating.
Do not move the heater after it has been turned off until the temperature has
cooled down.
Keep the ventilation opening of the cylinder enclosure free and clear of debris.
Do not paint the radiant screen, control panel or top canopy reflector.
Control compartment, burner and circulation air passageways of the heater must
be kept clean. Frequent cleaning may be required as necessary.
The LP tank should be turned off when the heater is not in use.
Check the heater immediately if any of the following occurs:
- The heater does not reach temperature.
- The burner makes popping noise during use (a slight noise is normal when the
burner is extinguished).
- Smell of gas in conjunction with extreme yellow tipping of the burner flames.
The LP regulator/hose assembly must be located out of pathways where people
may trip over it or in area where the hose will not be subject to accidental damage.
Any guard or other protective device removed for servicing the heater must be
replaced before operating the heater.
13

Advertisement

Table of Contents
loading

Table of Contents