Epson Stylus Color 660 Start Here Manual page 3

4 Install the Ink Cartridges
You must install both ink cartridges and leave them installed
or the printer won't work.
1. Plug the power cord into a grounded outlet.
Don't use an outlet that can be turned off by a wall
switch or timer, or one on the same circuit as a
large appliance. This may disrupt the power, which
can erase the printer's memory or damage its
power supply.
2. Lower the printer's output tray, then open the cover.
3. Press the power button to turn on the printer. The
power light flashes, the black and
lights come on, and the ink cartridge holders move left
to the installation position.
Always use the
on or off; never use an external switch, such as a
power strip switch.
color ink out
power button to turn the printer
4. Lift the two ink cartridge clamps.
Don't open an ink cartridge clamp or remove a
cartridge except to replace it with a new one. Once
you remove a cartridge, you can't reuse it, even if it
contains ink.
5. Remove the ink cartridges from their foil packages.
Then pull off only the yellow part of the tape seal on
the top of each cartridge.
You must remove the yellow tape seal from the top
of the cartridge or you will permanently damage it.
Don't pull off the blue part or remove the clear seal
from the bottom of the cartridge; ink will leak.