Epson Stylus Color 600 User Manual page 86

Troubleshooting
Possible cause
Your printer or application
software is installed
incorrectly.
Your computer doesn't
have enough memory to
handle the data in the file
you are printing.
Printing is stalled in Spool
Manager (Windows).
Printing is stalled in
Monitor2 (Macintosh).
The print heads are clogged
or the ink cartridges are too
old.
The paper out light is flashing or on
S
Possible cause
If flashing, paper is
jammed.
If on, paper is not loaded or
is loaded incorrectly.
A black or color ink out light is flashing or on
B A
Possible cause
If flashing, the ink supply is
getting low.
If on, the ink cartridge is
empty.
Solution
If the printer check prints correctly, check your printer and
application software for correct installation. If you're printing on a
Windows 95 network, you may need to set up your printer for
network printing, as described in Chapter 4.
Try one of the following:
Reduce the resolution of your image.
Select fewer colors or a lower resolution for your monitor.
Add more memory to your computer.
Delete the stalled print jobs in Spool Manager and resume printing;
see Chapter 4 for instructions.
Open the Extensions folder, EPSON folder, and Spool folder. Then
delete any queued files.
If the printer sounds like it's trying to print but doesn't feed paper,
clean the print heads; see Chapter 5 for instructions.
If cleaning doesn't help, replace the cartridges. For information on
cartridge life and replacement instructions, see Chapter 5.
Solution
Remove the paper and follow the guidelines for preventing jams
on page 6-13.
Load paper or remove the stack and reload it as described in the
Setup Guide or Chapter 3. Then press the E load/eject button to
turn off the light and resume printing.
Solution
You need to replace the indicated ink cartridge soon. Make sure
you have a new cartridge, then see Chapter 5 for instructions.
You must replace the indicated ink cartridge; see Chapter 5 for
instructions.
6-8