Epson Stylus Color 600 User Manual page 91

Paper doesn't feed
Try this
Remove the stack of paper
from the sheet feeder.
Multiple pages feed at the same time
Try this
Remove the stack of paper.
Paper jams inside the printer
Try this
Turn off your printer, open
the cover, and remove all
the paper that's inside,
including any little pieces
that may have torn off.
Then do this
Check that the paper:
Isn't curled or creased.
Isn't too old (see Chapter 3 or your paper packaging for more
information).
Isn't loaded above the arrow on the left edge guide.
Isn't jammed inside the printer. (If the S paper out light is
flashing, paper is jammed.)
Then reload the paper as described in Chapter 3, making sure the
left edge guide is adjusted to fit the paper's width.
Then do this
Make sure the paper isn't too thin (see the paper specifications
in the Appendix).
Fan the edges of the stack of paper to separate the sheets.
Reload the paper as described in the Setup Guide and
Chapter 3.
If more copies of a page or document are printing than you
expected, check the Copies settings in both the printer
settings dialog box and your application program. See
Chapter 1 for information.
Then do this
Reload the paper as described in the Setup Guide and Chapter 3.
If your paper jams frequently, make sure you:
Use smooth, high-quality paper, loaded printable side up.
Fan the stack and then even the edges before loading it.
Don't load paper above the arrow mark on the left edge guide.
Adjust the left edge guide to fit the width of your paper.
6-13
Troubleshooting