Table of Contents
Advertisement
Quick user guide
1.
Check the rating label for correct AC voltage.
2.
Connect to AC socket, Bulk LED is on then quickly moves to Abs LED
3.
The LEAD LED is the default setting of battery type.
4.
Disconnect AC and connect output to battery then reconnect AC.
USING THE SET BUTTON
Note: LEAD ● means LED for LEAD on panel indicator.
a.
Short Presses for battery type and DC source selection.
Short Presses on the SET button will cycle as below:
LEAD ●→AGM ●→LiFePo4 ●→13.5V ●●●→LEAD ● →AGM ● →LiFePo4 ●
→13.5V ●●●
Remark: ●●● 3 battery LED are on for 13.5V DC Source Mode
All 3 battery LED ●●● are on shows output set at 13.5V with 20A Max.
b.
Just stop at your desired battery type DC Source Mode and charger.
*Will retain the selected setting even it has been disconnected from AC and
battery.
c.
Long Presses (5 sec) for LOW MODE, NIGHT MODE, EQ MODE & EXIT.
When battery type set at AGM or LiFePo4.
Long Press (5 sec)
for LOW→NIGHT→EXIT→LOW→NIGHT→EXIT→LOW→NIGHT→EXIT
When battery type set at LEAD
Long Press (5 sec)
for LOW→NIGHT→EQ→EXIT→LOW→NIGHT→EQ→EXIT→
5.
LOW = Low Power Mode: LED flickers
to set charger to Half Power Mode of 15Amp Maximum.
6.
NIGHT = Night Mode: LED solid
8 hour without FAN cool and only 10Amp maximum output.
Charger return to normal max 20Amp at the end of 8 hours.
7.
Exit from Night mode or Low Power Mode by 5 sec long press to unlock and
further 5 sec press to exit
Remark:
Auto-Lock Up of charger.
The charger will be locked with the desired selection 3 minutes after no further press on
the SET button during operation. If SET button is pressed before Lock Up starts, a new
3 minute count down comes in.
Unlock the charger:
5 second long press on the SET button to unlock and all LEDs will flash to confirm that
charger has been unlocked.
WiFi reset: (For WiFi version only)
After unlock the charger, 15 second long press on the SET button to LEDs will flash to
reset the WiFi to factory defauclt setting.
Advertisement
Table of Contents
