Related Manuals for Bosch PCD345DA
Summary of Contents for Bosch PCD345DA
- Page 1 This cooktop is for use with Natural Gas and Universal LPG Leave this instructions with the owner PCD345DA USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS...
-
Page 2: Table Of Contents
Converting the cooktop from Nat. Gas to Universal LPG ...6 Changing the nozzles of the burners on the cooktop ....6 Additional information on products, accessories, replacement Adjustment of the taps...............6 parts and services can be found at www.bosch-home.com and in the online shop www.bosch-eshop.com Safety considerations For your safety For pressure testing in excess of 3.5 kPa (1/2 psig) the... -
Page 3: Installation
Note: To avoid jeopardising the electrical safety of the SHOULD THE RELEVANT CONDITIONS NOT BE PROPERLY appliance, it is forbidden to use high-pressure or steam jet SATISFIED, THE INSTALLER, AND NOT THE cleaning devices. MANUFACTURER, SHALL BE HELD LIABLE. Installation Statutory requirements Preparing to install Refer to AS/NZS 5601.1 for piping size details. -
Page 4: Clearances
PP PP PP PP PP PP PLQ PP PP PLQ PP PLQ PP PLQ PP PLQ PP PLQ PP PP PLQ PP PLQ PP PP PP PLQ PP... -
Page 5: Installation Of Cooktop Into The Kitchen Bench
The shield overall dimensions must be 560 mm wide x Connection ■ 480 mm deep. Electrical Provide cut-out in right hand rear of shield of 80 mm wide x ■ 80 mm deep to provide for gas regulator / LP connection An electrical 10 amp socket needs to be within 1 m of the fitting. -
Page 6: Converting The Cooktop From Nat. Gas To Universal Lpg
Flexible Hose: If installing with a hose assembly, it must Ensure that it is completely tightened in order to guarantee ■ comply with AS/NZS 1869, 10 mm ID, class B or D, no more the seal. than 1.2 m long and installed in accordance with AS/NZS 5601.1. -
Page 7: Operating Instructions
Operating instructions Burner locations It is essential to ensure that all the burner parts and pan 3&''$ supports are correctly installed for the appliance to work correctly. Do not swap the burner caps around. Pan supports Switching on automatically Control knobs If your hob can be switched on automatically (ignition Auxiliary burner (up to 1 kW) sparkers):... -
Page 8: Cooking Pans
Power levels Do not use large pots or heavy weights which can bend the The progressive control knobs can be used to control the pan support or deflect flame power needed, from minimum to maximum power. onto the hotplate. Setting Û... -
Page 9: Cleaning And Maintenance
Cleaning and maintenance Caution! Do not use steam cleaners. This could damage the hob. ■ Cleaning If your hob is fitted with a glass or aluminium panel, never use ■ Once the appliance is cool, use a sponge to clean it with soap a knife, scraper or similar implement to clean the point where and water. -
Page 10: Wiring Diagram
Wiring diagram Switch Blue wire Brown wire Terminal Ignition module... - Page 11 Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Germany www.bosch-home.com *9000941667* 9000941667...