H.
Place the shrinktube over the connected wires and
melt the shrinktube with the hot-air gun.
*Melting the shrinktube will prevent that the
connected wires will come in contact with the
water in the water tank.
Note : When melting the shrinktube make
movements from left to right so that the
shrinktube can melt gradually.
CAUTION : Make sure that the shrinktube is melted completely to the white wire insulation as
otherwise a short circuit can occur.
Also keep in mind that the shrinktube should not be touched after melting, because
of burning.
Connect flush tube back onto
I.
the pump and screw the pump
back into the water tank.
Place tissue holder and
J.
tissue well back into
the water tank.
Leaflet no. 21036/062001
8