Step 1; Step 2; Hardware & Tool Required - modway EEI-2142 Quick Start Manual

EEI –2142

STEP 1:

Please find the package of Legs (2) and hardware on the top of the seat.
Then put the Chair Body (1) upside down on a carpeted or padded area by two adults to
make the corners fully visible.
Position one of Legs (2) at one of the four wooden corners.
Insert 2 pieces of Spring Washer ( ( ( ( B) ) ) ) , Flat Washer (C) into 2 pieces of Bolts ( ( ( ( A) ) ) ) as shown.
Then insert assembled 2 pieces of Bolts (A) into the corner to connect one piece of the Leg (2).
Use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the remaining three pieces of Legs (2).
1
Ax8

STEP 2:

Carefully turn over the chair .
Customer Service 908-368-1025︱ ︱ ︱ ︱ www.modwayfurniture.com
CHAIR
2
D
C
B
A
2
Bx8 Cx8
Assembly is completed. The chair is ready to enjoy now!
A
A
1
A
A
Dx1
2
2
Hardware & Tool required
Page 2 of 2