Advertisement
IMPORTANT SAFETY INFORMATION
RECOMMENDED SURFACING
WARNING:
To reduce the likelihood of serious head injuries, install shock-absorbing protective surfacing under and around this unit. The protective surfacing should be
applied to a depth suitable for the unit height in accordance with ASTM F1292. Follow the guidelines below for each type of surfacing:
NOTE:
• DO NOT install this unit over concrete, asphalt, packed earth, grass,
carpet, or any other hard surface. A fall onto a hard surface can result in
serious injury to the user. Grass and dirt are not considered protective
surfacing because wear and environmental factors can reduce their
shock-absorbing e ectiveness. Carpeting and thin mats are not
adequate protective surfacing.
*Ground level equipment, such as a sandbox, activity wall, playhouse or
other equipment that has no elevated play surface, does not need any
protective surfacing.
UNIT POSITIONING
• PLEASE REFER TO CRITICAL FALL HEIGHT INFORMATION.
• This unit should be installed on a level surface by an ADULT with an
ADULT ASSISTANT. Place the unit on a at area to minimize ground
preparation.
• Choose a level location for this unit to reduce the likelihood of the play
set tipping over and loose- ll surfacing material washing away during
heavy rains.
• Place this unit no less than 6 feet (2 meters) from any structure or
obstruction, such as a fence, garage, house, overhang, branches,
laundry lines, or electrical wires.
• Provide enough room so that children may play on this unit safely. For
example, for structures with multiple play activities, a slide should not
exit in front of a swing.
• Place this unit where adults are easily able to watch children at play.
VERTICAL HEIGHT
6'7" (2m)
• DO NOT install loose ll surfacing over hard surfaces like concrete or
asphalt.
• Shredded bark mulch, wood chips, ne sand and ne gravel are added as
shock-absorbing materials after assembly. If used properly, these materials
can absorb some of the impact of a child's fall.
• All surface material should extend a minimum of 6 ft. (2m) in all
directions around the play area.
• DO NOT apply surfacing materials until after the unit is completely
assembled and anchored.
• Create a play area free of obstacles that could cause injuries - such
as low-hanging tree branches, overhead wires, tree stumps or roots,
large rocks, bricks, and concrete.
• Do not build this unit on top of surfacing material.
4
Step 81:
Remove the Light Box Screw and Light Box Cover from the Light Box (DL01). Insert
(3) fresh 1.5V A A (LR6) Alkaline Batteries. Make sure the positive and the negative
ends face the proper direction as indicated inside the battery compartment.
Reattach the Light Box Cover and secure using the Light Box Screw.
Step 82:
Place the Light Box in the pocket of the Tarp.
3x AA Batteries
1.5V AA/LR6
1.5V AA/LR6
1.5V AA/LR6
53
Advertisement
