Advertisement
TOOLS YOU WILL NEED (NOT INCLUDED)
To complete this procedure, you will need a Power Drill, a Hammer, a Rubber Mallet, a Metric
Socket Wrench Set, a Level, a Square, an Adjustable Wrench, a Tape Measure, a Ladder (not
pictured), and (3) AA Batteries. Optionally, you may need a Flathead Screwdriver. Optionally,
you may need a Flathead Screwdriver.
Hardware listed is the quantity needed to build the unit. Extra hardware is included.
(31) Bolt (A1)
(26) Bolt (A2)
(3) Nut (A3)
(12) Nut (L1)
(26) Nut (A2)
(18) Screw (C3)
(276) Screw (C2)
TOOLS
HARDWARE
(31) Nut (A1)
(3) Bolt (A3)
(24) Screw (C1)
(23) Screw (B1)
(9) Screw (C5)
(18) Screw (C4)
10
Step 69:
Attach (1) Roof Board (C11) to the Tower Legs (C01), (L03), and (L04) using (3) Screws
(B1). Ensure that the end with the overhang is placed over the Tower Leg (C01).
Step 70:
Attach (1) Roof Support (J1) to the Roof Board (C11) using (1) Screw (C3). Attach the
Roof Support to Tower Leg (L05) using (1) Screw (C4). Ensure the top edge of the Roof
Support is ush with the top edge of the Roof Board.
47
Advertisement
