Epson Stylus C84WN Start Here Manual page 7

5
Make sure Network is selected, then click Browse.
6
Click to expand the network path, then click the + next to
Epson _ Ipr and select your printer.
7
Click OK, then click OK again. Click Apply on the Details tab.
8
To test the connection, click the General tab and click
Print Test Page.
If the test page prints, click Yes, then click OK to close the Properties
window.
If it doesn't print, try the suggestions under "Problems?" below.
Congratulations! You're ready for wireless printing. See Printer Basics
for more information.
Problems?
The print server's status
page doesn't print, or it
indicates that zero bytes
were transmitted
or received.
The Wireless Server
Search window fails to
pick up a signal from
the print server.
Test button
Make sure the parallel cable is securely
connected to both the print server and your
computer.
Make sure the printer is on. Check the printer's
lights to see if there is a problem. See Printer
Basics for details.
Unplug the AC adapter from the print server
and plug it in again. Then press the print
server's test button for 10 seconds to reset
it to its factory defaults. If you still have
problems, contact EPSON.
Make sure the print server, printer, and access
point are not near a cordless phone unit,
microwave oven, Bluetooth
metal object. Try moving them to a new
location, or try moving them closer to
each other.
Press the print server's test button for 10
seconds to reset it. On Macintosh, select your
wireless network again.
Try restarting your computer.
On Macintosh, make sure that AirPort is
on, and that both AppleTalk and TCP/ IP
are enabled.
Confirm the connection between the computer
and your access point or base station. If you
have problems establishing a connection,
reset the access point or base station.
TM device, or large
continue