Danger of injury caused by
implosion.
Damage and cracks in jars or glass/
twist-off lids can cause implosion.
Only vacuum jars and lids which are
in perfect condition.
Only vacuum jars on vacuum
setting 1 or 2.
Damage caused by deformation
of glass lids.
The glass lid may become deformed
due to the negative pressure that
occurs.
Only vacuum seal jars up to a
maximum height of 8 cm in order to
maintain a safety gap of at least
1 cm between the lid on the jar and
the glass lid on the drawer.
Vacuum sealing preserving jars
and jars with twist-off lids
Close the jar with its appropriate lid
and rubber seal or with the twist-off
lid.
Open the drawer and the glass lid.
Place the jar in the vacuum chamber.
Switch the drawer on with the On/
Off sensor control.
The segment bar indicator lights above
the and sensor controls light up.
Touch the sensor control
repeatedly until the segment bar
indicator light for vacuum setting 1
or 2 lights up.
Touch the sensor control
repeatedly until the segment bar
indicator light for sealing level 1 lights
up.
Close the glass lid and press it down
lightly.
Tip: Press the small black triangle to
close the glass lid.
The vacuum sealing process will start.
The sensor control goes out and
the sensor control lights up.
Operation
25