Table of Contents
Advertisement
The workpiece is not cut fully. This may be caused by:
The cutting current is too low.
The cutting speed is too high.
The electrode and nozzle of the torch are burned.
The workpiece is too thick.
Molten slag drops from the bottom of workpiece. This may be caused by:
The cutting speed is too low.
The electrode and nozzle of the torch are burned.
The cutting current is too high.
3.5 Cutting parameters table
Select proper current according to the cutting parameters table, workpiece material, cutting
thickness and cutting speed, etc. (The figure in the below table is an approximation. )
Table 3-1: Cutting speed (m/min) when cutting current is 55A
Cutting thickness (mm)
Mild steel
Galvanized steel
Stainless steel
Aluminum
Brass
Red copper
3.6 Replacement of electrode and nozzle
When the phenomena below occur, the electrode and nozzle should be replaced. Otherwise,
there will be strong arc in the nozzle, which will break down the electrode and the nozzle, or even
burn the torch. Nozzles of different models are different, so ensure the nozzle is of the same
model when replacing it.
Electrode wear＞1.5mm
Distortion of the nozzle
Cutting speed declining, arc with green flame
Difficult in arc ignition
Irregular cut
0.1
1
2
3
8
1.5
8
1.5
8
1.5
8
1.5
0.75
0.75
12
4
5
6
7
0.4
0.4
0.4
8
9
Hide quick links:
Advertisement
Table of Contents
