Skil CR541801 Owner's Manual page 18

The LED light will flash more slowly to indicate that the battery pack is at low-battery capacity.
Recharge the battery pack.
Cutting with the Circular Saw (Fig.11)
Refer to the figures in this section to learn the correct and incorrect ways of handling the saw.
Fig. 11
WARNING
To make sawing easier and safer, always maintain proper control of the saw. Loss of
•
control could cause an accident resulting in serious injury.
Maintain a firm grip and operate the trigger switch with a decisive action. Never force the
•
saw. Use light and continuous pressure.
When lifting the saw from the workpiece, the blade is exposed on the underside of the
•
saw until the lower blade guard closes. Make sure that the lower blade guard is closed
before setting the saw down.
To make the safest and best possible cut, follow these helpful hints:
a. Hold the saw firmly with both hands.
b. Avoid placing your hand on the workpiece while making a cut.
c. Support the workpiece so that the cut is always to the operator's side and not directly in line
with the operator's body.
d. Support the workpiece near the cut.
e. Clamp the workpiece securely so that the workpiece will not move during the cut.
18