Testing The Printer - Epson Stylus 1500 Manual

Epson stylus 1500: product information

Hide thumbs Also See for Stylus 1500:

Service manual (185 pages)

Reference manual (119 pages)

Software manual (65 pages)

Table Of Contents

Table of Contents

Loading Plain Paper in the Sheet Feeder

You can load up to 100 sheets of plain paper. Always load

paper with the printable surface facing down. The printable

surface is marked with an arrow on most paper packaging.

1. Make sure the paper-release lever is set to the single-sheet

position.

2. Raise the output tray until it locks in the upright position.

3. Slide the right edge guide to the left as far as it will go.

Slide the left edge guide to match your paper's width.

4. Move the center support midway between the edge guides.

Then gently extend the rear edge guide until it stops.

Ink Jet Printers

TITLE

LM-9.EPS

EPSON AMERICA, INC.

Documentation Department

DATE

9/7/95

20770 Madrona Avenue, Torrance, CA 90503

(310) 782-0770

DRAWN BY

B. Levert

5. Fan a stack of paper; then tap it on a flat surface to even the

edges.

6. Load the stack of paper into the sheet feeder. Make sure the

right edge of the stack is against the right edge guide.

Slide the left edge guide against the left edge of the paper.

Note:

The sheet feeder can hold up to 100 sheets of 17-lb (64 g/m

plain paper. Do not load paper above the arrow mark, which is

located on the inside surface of the edge guide.

7. Adjust the rear edge guide to match the length of your

paper.

When you load paper in the landscape direction (wider

than it is tall), the rear edge guide may not match the

length of your paper. In this case, remove the rear edge

guide and re-insert it as shown.

8. Lower the output tray to the printing position. Make sure

that the rear edge guide of the paper tray is positioned

under the output tray. The rear edge guide must be

under the output tray to allow room for the paper loaded

in the sheet feeder and to prevent a paper jam.