eLTE2.2 eA660 Series CPE
User Guide
Figure 3-15 Fixing the angle adjusting component onto the mounting frame
The gears of the horizontal angle adjusting part is tightly fit in. Consequently, the horizontal
angle is difficult to adjust. When adjusting the horizontal angle, after you loosen the hex
screws, you must lift the front end of the angle adjusting component to separate the gears.
Issue 01 (2013-10-30)
If you correctly install the angle adjusting component, you will hear a loud click.
Use the M8 hex key to loosen the the hex screws on the left of the angle adjusting component, and
adjust the vertical angle by rotating the front end of the angle adjusting component, as shown in
Figure
3-16. Then tighten the hex screws.
Figure 3-16 Adjusting the vertical angle
Use the M8 hex key to loosen the the hex screws on the left of the angle adjusting component, and
adjust the vertical angle by rotating the front end of the angle adjusting component, as shown in
Figure
3-17. Then tighten the hex screws.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Installation
23