Table of Contents
Advertisement
8. Installation Guidelines
•
Make sure the appliance is fully intact and all fittings are complete.
•
Make sure the power supply, grounding and cabling meet the specified requirements.
•
Make sure the water pressure on the water supply line meets the specified requirements.
•
Before installing and using the appliance, make sure there are no blockages in the water
inlet or drain pipes.
•
It is recommended to use stainless steel braided flex piping.
•
Never solder the pipes or fittings.
•
Before connecting to the power supply, you must complete all mounting and plumbing
connections, and test the water supply. Make sure water flows sufficiently and evenly. Make
sure there are no leaks.
•
The wires in the faucet's power cable must be connected
9. Installation
Complete all mounting and plumbing connections before connecting to the power
supply.
Operating the faucet without a water supply may cause damage to the appliance
and will void the warranty.
Cable under sink installation
Position the appliance upright with plumbing connections facing down.
1. Line up the rubber pad. (Fig. 1)
2. Feed the faucet's water pipe and cable through the hole. (Fig. 2)
3. Line up the rubber pad and Fixture disk. (Fig. 3)
4. Feed the mounting element. (Fig. 4)
Make sure the mounting elements are aligned.
Then tighten the mounting nut and make sure the faucet is secure.
1
1
2
2
3
3
4
4
9
Advertisement
Table of Contents
