Epson LX-300+ Product Information page 11

Epson lx-300+: product information

Hide thumbs Also See for LX-300+:

5. After you set the tear-off position, press the

to turn off the Micro Adjust mode.

6. Tear off the printed page(s).

When you resume printing, the printer automatically feeds the

paper back to the top-of-form position.

You can load single-sheet paper one sheet at a time using the

printer's paper guide. The printer accommodates single sheets

from 3.9 to 10.1 inches (100 to 257 mm) wide.

Before printing on single-sheet multipart forms, envelopes, or

other special paper, be sure to the set the paper thickness lever

to the appropriate position. See "Adjusting the Paper Thickness

Lever" on page 12 for details.

1. Make sure the paper-release lever is pushed back to the

single-sheet position, as shown below. Raise the paper guide

upright.

button

2. Slide the left edge guide until it locks in place at the guide

mark, then adjust the right edge guide to match the width

of your paper.

3. Slide a sheet of paper down firmly between the edge guides

until it meets resistance.

The printer accommodates multipart forms, labels, and

envelopes. For multipart forms and labels, you should not print

any closer than 0.5 inch or 13 mm from either side of the paper.

5/00

EPSON LX-300+