Kodak REELZ User Manual page 8

7. Hold the film firmly in between your pointer finger and thumb. Slowly place the film under
the first black tab (tab farthest left in the film area). Then, carefully twist the film and place
it under the second black tab in the film area.
8. Twist the film slightly again to fit the film under the third tab.
9. Press the film down near the fourth tab and make sure the film clips in place.
10. Press your finger down once more on the film to make sure the film is under all four (4) tabs.
A click should be heard when the film is probably under each tab.
NOTES: If the film is placed into the slot correctly, the gray pin will automatically adjust itself
into the correct position when recording begins.
When loading a new film into the film scanner, your film may appear out of frame
when first on screen. To properly center and position your film correctly,
slide the film type switch back and forth once. By sliding the film type switch back
and forth, the reel on the reel shaft will spin moving the film into its proper position.
When using 8 mm film, slide the switch over to the Super 8 film selection then back
over to the 8 mm film selection. When using Super 8 film, slide the switch over to the
8 mm film selection then back over to the Super 8 mm film selection.
8