Testing The Printer In The Cut Sheet Feeder Mode - Epson LQ-510 User Manual

Testing the Printer in the Cut Sheet Feeder Mode

When you perform the cut sheet feeder self test, the printer counts
the number of lines on the page. As shown on the following page,
the number of lines counted is printed out at the bottom of the first
test page. This number is the default page-length setting. This
setting, however, can be overridden by software commands.
Running the self test is the same as when the cut sheet feeder mode
is off. The steps below are for a self test in draft mode.
1. Make sure that the printer is turned off and a stack of paper is in
the bin. Check that the cut sheet feeder mode is selected and the
paper release lever is pushed to the rear.
2. While holding down the LINE FEED button, turn on the printer.
(For LQ mode, press the FORM FEED button instead of the LINE
FEED button.)
Using the Printer Options
The Cut Sheet Feeder
5-9