Brother 1034D Serger Quick Reference Manual page 10

Brother 1034D Serger Quick Reference Guide
Removing/Replacing the Needles
1. Using the hexagonal wrench from the supplies bag,
loosen the small screw directly above the needles.
Tighten
Loosen
2. Grab the needles between your thumb and forefinger
and pull down and out.
3. To replace needles, hold the same way (both at the
same time) and insert the needles into the slot as far
as they will go.
4. Tighten the screw until snug.
5. To use only one needle, use the same method but
insert only one needle. Different stitches require the
use of either the left or right needle. Refer to the
"Serger Techniques" guide for stitch details.