Epson LQ-2550 User Manual page 83

PARITY *
*Displayed only when the serial interface setting is selected
The LQ-2550 comes with preset default values, which can be printed out
using the PRINT GLJT SETTINGS mode. These default values are shown
below.
INTERFACE
PARITY
AUTO L,INE FEED
If your computer has a parallel interface, the preset defaults should work
correctly in most cases. You may wish to change the DEFAULT MACRO
settings, however, to match your usual style of printing. Here are a few
additional tips on setting the defaults.
l
change the interface setting to Serial. (If you are using an optional
interface board, be sure that the interface setting is Pa r a 11 e 1,
regardless of what type of interface it actually is. See the section on
interface boards in Chapter 7 for more information.)
l
interface. (Be sure to first set the interface setting to Serial . BALJD
set to Se r i a 1.) Check your computer manual for the correct baud
rate and parity settings. Your computer and printer should be set to
the same baud rate and parity.
Using the Printer
Disable, Enable
D e f a u l t , set.t;ing
* 9 6 0 0 R P S
P a r a l l e l
*
None
O f f
D i s a b l e
3-19