Using The Audio Input; Usb Charge; Specifications - Sylvania SCR1986BT-AS Instruction Manual

Using the Audio Input

Require a 3.5mm audio cable (not include).
1. Connect a 3.5mm audio cable to the AUX IN JACK on the rear of the unit
and the audio output on an audio device.
2. Press the POWER / SOURCE BUTTON to turn the unit on.
3. Press the POWER / SOURCE BUTTON to switch to AUX IN mode.
4. Use the native controls on the connected device to play your audio
through the unit.
1. Make sure the unit is plugged into the wall
2. Using the appropriate USB charging cable (not included), connect one
end to the device and the other to the USB Charger on the unit.
Refer to the user's manual for your specific device for manufacturers
required charging amperage as well as determining the appropriate cable
for your device before charging.
Note: This device uses a USB charging port with a 1000mA maximum
charging capacity, making it unsuitable for charging iPads.
3. The device will now charge.
Power Output........................................ 2 watt RMS Mono
USB Charging....................................... DC 5V, 1A
AC Power.............................................. AC120V - 240V 5V 1.5A ~ 50/60Hz
Battery Size (For Backup Only)............. CR2032 x 1pc
Radio Frequency................................... FM: 87.5 - 108MHz

USB CHARGE

SPECIFICATIONS

9