MELICONI CONTROL 2 Simple Quick Start Manual page 4

If certain buttons do not work correctly, you are probably using an incorrect code destined for a very similar device; at this
point ignore the SMS list and consult the SETTING VIA BRAND RESEARCH chapter to find a more suitable code.
NOTE: If you don't receive an SMS on your mobile phone or if the message says ERROR or NO CODE, it means the
system has not been able to process the data you have sent. Do not send another SMS, only use the SETTING VIA
BRAND RESEARCH procedure or contact the customer service.
CAUTION: the search procedure could take several minutes.
If you want to use CONTROL 2 Simple to control 2 devices at the same time (TV + DECODER) firstly search the code for the
TV and then the code for the DECODER. To control one single device only do what interests.
A) Look in the table at the beginning of the booklet, referring to the column relating to the type,
the brand of device which you wish to control, and note the corresponding number in the
BUTTON column. If the brand is not present using zero "0".
B) Stand in front of the device to be controlled and make sure it is ON (not in stand-by).
If necessary, switch it on using the original remote control (if this is still working) or the buttons
present on the device itself. (on TVs they can be on the side or the top).
C) Press and hold on the MELICONI remote control for at least 6 seconds both
buttons for the TV setting (or
D) When the indicator light flashes, release and immediately press the numeric button identified in
the table for a moment.
E) Pointing the remote control towards the device to be controlled, press and hold on the
MELICONI remote control the ON/OFF
CAUTION: you may have to keep the button pressed for a few minutes before the device
switches off.
F) When the device switches off, IMMEDIATELY RELEASE the button and press the
G) Three final flashes indicate that the operation has been completed successfully.
Check that the MELICONI remote control operates your device also with the other main functions; if it does not,
If, after various attempts, do not get a satisfactory result REPEAT the procedure from step B, using 0 (zero) as brand
NOTE: During the search the indicator stops flashing and the remote control exits the search mode in the following
cases:
• if for 30 seconds the indicated button is not pressed or if another button is pressed.
• if the list of codes to find is terminated. In this case consult the
customer service.
SETTING VIA BRAND RESEARCH
(only to be performed if the specific code could not be found)
[ ] [ ]
P –
P + e for DECODER setting).
[ ]
button.
ADDITIONAL CHECK
REPEAT the procedure from step B using the same brand number.
(example: TV SONY = 3)
[
P +
EXAMPLE: 3
number.
www.meliconi.com/guide
] [ ]
e +
[ ]
OK button.
website or contact the