Inserting The Batteries - MELICONI CONTROL 2 Simple Quick Start Manual

Thank you for choosing a Meliconi remote control.
The CONTROL 2 Simple remote control is designed to command a TV and a DECODER (satellite or digital terrestrial).
CONTROL 2 Simple is a simplified remote control; it provides ONLY the functions on the keypad.
IMPORTANT! When the remote control is set to control only the TV, all the buttons will control the TV; whilst when it is set to
control 2 devices (TV + DECODER), only the black buttons will control the TV, whilst the white buttons will control the
DECODER.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
The remote control must not be exposed to excessive heat sources or fire.
The product is not a toy. Keep out of reach of children or domestic animals.
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the
package. Insert with the correct polarity as shown in figure.
DO NOT use rechargeable batteries.
BATTERIES TEST: Press and hold the ON/OFF
remains on continuously until the button is released. If the light is off or blinks, the inserted
batteries are low, therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
Before using the remote control, for each device you wish to control, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
INTERNET
Go to the website listed above, or use the qr-code on the side, to access online tool SEARCH
ACTIVATION CODE.
Once you have found the specifi c code for your device, set it in the remote control as described
in the ENTERING THE CODE DIRECTLY chapter.
Keep this booklet for future reference
SAFETY WARNINGS

INSERTING THE BATTERIES

[ ]
button and check that the indicator light
ACTIVATION OF REMOTE CONTROL
SETTING VIA INTERNET
www.meliconi.com/guide
MOBILE (SMS)
BRAND
RESEARCH