Installing The Postscript Printer Driver For The Usb Interface - Epson EPL-N3000 Reference Manual

6. Select the INF file for the version of the Windows operating
system that you are running and continue with the
installation according to the on-screen instructions until the
screen asking you to select the port the printer is connected to
is displayed.
7. Select LPT1 as the port the printer is connected to, and then
click Next. Follow the on-screen instructions for the rest of the
installation.
8. When installation is done, click Finish.

Installing the PostScript printer driver for the USB interface

Follow these steps to install the PostScript printer driver for the
USB interface:
Note:
The USB interface is not available for printing under Windows 95.
If the Windows driver and the Adobe PS driver for an Epson printer
with a USB connection have already been installed on your
computer, follow the installation procedure explained in the
previous section, "Driver installation for the parallel interface
connection," but make sure to select USB as the port in step 7. If
you have not installed an Epson USB printer driver on your
computer, follow the installation procedure below.
You must have at least 6 MB of free space on your hard disk drive
to install the PostScript printer driver.
1. Without connecting the printer to your computer, turn on
both the computer and the printer.
2. Once Windows has started, connect your computer to the
printer with a USB cable.
3. The Add New Hardware Wizard will launch automatically.
Click Next to start the installation of the USB printer driver.
Using the PostScript Printer Software (Windows)
4
4
4
4
4
4
4
4
4
4
4
4
91