Table of Contents
Advertisement
Temperature Control
1. The temperature in the refrigerator is controlled by turning the thermostat knob
installed on the interior right wall of the unit.
2. At the thermostat setting of "0", the compressor is stopped and no cooling
takes place (although electricity still powers the unit). As the knob is turned
from "1" up through "7", the set temperature decreases, with "7" indicating the
lowest possible temperature.
3. In normal use, the selector should be set to "3" or "4".
NOTE: If the refrigerator is unplugged, has lost power, or is turned off, you
must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the refrigerator will not start.
Defrosting
The refrigerator defrosts automatically. While the compressor is operating, ice
deposits on the inner back wall; later, when the compressor is not operating, the
ice melts. Water drops collect and drain through the outlet in the inner back wall
into the drain pan situated above the compressor. There the water evaporates.
If ice forms on the inner rear wall, see Troubleshooting on page 9.
1. The appliance should be positioned so that the plug is easily accessible.
2. If the power cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
3. The appliance is for indoor use only.
4. Do not use the refrigerator to store volatile or flammable substances like ether,
methanol or gasoline.
5. Do not set anything heavy on the top of refrigerator or allow water to be poured
on it.
6. The refrigerator should be connected to an independent electrical socket and
should be safely grounded.
7. If the unit loses electrical power, do not return power to the unit any sooner
than 5 minutes after the power went off. Otherwise, the compressor could be
damaged.
8. To save electricity, be sure air can circulate freely around the unit during
operation. Check that the packing base has been removed.
9. Be sure to keep the electrical cable away from the compressor and condenser,
or its insulation could be damaged by high temperatures.
Operation
Notes
6
Advertisement
Table of Contents
